Hello, I am planning to use the CM4 module (8GB RAM or 4GB RAM) and the CM4 I/O Board to simultaneously operate the Raspberry Pi Camera Module 3 and the IMX219 wide-angle camera.
Is it possible to use both the Camera Module 3 and the IMX219 camera at the same time with the CM4 module and CM4 I/O Board? I hope that the sync difference between the two camera inputs is not too significant (below approximately 50ms).
P.S. The method I previously attempted to use two cameras was with the Arducam camera multi-board, but it was not possible to use two different types of cameras. Even when using the same type, it seemed that the frame rate did not even reach 30 frames.
Is it possible to use both the Camera Module 3 and the IMX219 camera at the same time with the CM4 module and CM4 I/O Board? I hope that the sync difference between the two camera inputs is not too significant (below approximately 50ms).
P.S. The method I previously attempted to use two cameras was with the Arducam camera multi-board, but it was not possible to use two different types of cameras. Even when using the same type, it seemed that the frame rate did not even reach 30 frames.
Statistics: Posted by bok960731 — Thu Nov 07, 2024 5:28 am — Replies 1 — Views 16