Hi,
My PI 400 boots up and I can see the output on the TV, but then it seems once the SD card loads, the display stops and there is NO SIGNAL on the TV. This is through HDMI and the cable that came with the pi.
In other threads, and in this troubleshooting file (https://elinux.org/R-Pi_Troubleshooting#Display) I have seen this advice:
hdmi_force_hotplug=1
config_hdmi_boost=4
I have uncommented those lines in my config.txt file, but it doesn't make any difference.
I have tried 3 SD cards (2 have retropi versions loaded). All have the same problem (initially there is a signal, then it is lost).
BTW, the bootup has worked on an older Samsung TV (which I don't have access to now). I don't have a differebt TV or monitor to test on.
Anyone have any other suggestions?
Thanks
Waterpi94
My PI 400 boots up and I can see the output on the TV, but then it seems once the SD card loads, the display stops and there is NO SIGNAL on the TV. This is through HDMI and the cable that came with the pi.
In other threads, and in this troubleshooting file (https://elinux.org/R-Pi_Troubleshooting#Display) I have seen this advice:
hdmi_force_hotplug=1
config_hdmi_boost=4
I have uncommented those lines in my config.txt file, but it doesn't make any difference.
I have tried 3 SD cards (2 have retropi versions loaded). All have the same problem (initially there is a signal, then it is lost).
BTW, the bootup has worked on an older Samsung TV (which I don't have access to now). I don't have a differebt TV or monitor to test on.
Anyone have any other suggestions?
Thanks
Waterpi94
Statistics: Posted by waterpi94 — Sat Aug 03, 2024 6:58 am — Replies 1 — Views 9