I was using my raspberry pi 3 with 2 l9100s motor drivers which i gave 3v connection each from my raspberry pi using a common ground too. The motors werent spinning so i assumed there wasnt enough voltage going to both drivers so i tried to only use one by unplugging the ground. As soon as i unplugged the ground the display went off and the connection was lost. When i try and boot my pi now the ACT led that usually indicates a successful connection between the SD card doesnt blink. Please help
Statistics: Posted by spavster — Fri May 17, 2024 5:55 pm — Replies 0 — Views 21